Tactical Scorpion Gear AR500 Steel Shooting Target Boar 18″ x 11″ x 3/8″ Gong

The Tactical Scorpion Gear AR500 Steel Shooting Target Boar 18″ x 11″ x 3/8″ Gong is equipped with two 1/2″ mounting holes with thick ears to take hits without breaking.  Hang from both holes for more stability or hang from a single hole.  These targets are a must have for any shooting range.

Tactical Scorpion Gear uses a CNC laser cutting table to produce of all their AR500 products.  This assures that the metal stays strong during the manufacturing process so that only the highest quality AR500 targets are produced.

Most AR500 is cut with plasma cutters as they are inexpensive and relatively small compared to other methods.  Plasma cutting cuts slowly and puts a lot of heat into the steel (a submerged plasma cutting machine is no better).  This excess heat can result in excessive chipping and damage near the cut edge during use and can easily shatter when shot.  Plasma cutting generates large amounts of heat that is deposited into the target, softening its edges. The heat-affected zone (HAZ) generated by plasma cutting is the largest out of the most commonly used methods for cutting abrasion resistant steel.

• Superior Material: AR500 3/8″ steel with 477 – 550 BHN
• Minimum surface hardness of 477 BHN.  Core hardness 450 min BHN

3/8″ AR500 steel targets work great for the following calibers 223, 5.56, 5.45×39, 7.62×39 and 308.  For velocities over 3000fps MV use at 200 yards minimum. Handguns should be used no closer than 10 yards and rifles 100 yards.  Please view our short article on the proper use AR500 targets and target safety Here

Additional Information:

• All of our 3/8″ targets carry the manufacturers limited lifetime guarantee from breakage
• Part number: TSG-GGBOAR
• Package Contents: One Boar AR500 steel gong target
• Weight: 16 pounds